FAQ
Do I need to register my Quilter product for warranty purposes?
(Click for info)
Is it OK to run with no load on the speaker output?
(Click for info)
Can I use this amp without a speaker cabinet?
(Click for info)
Intermittent volume drop or scratchy tone.
(Click for info)
What will happen if I am plugged in to a mixer and someone sends phantom power?
(Click for info)
Does this amp work on 230 volts? 100 volts? 120 volts?
(Click for info)
How do I use the direct out?
(Click for info)
What about Panoptigon Disc Royalties?
(Click for info)
Are all models cab sim out?
(Click for info)
Can I use an “X” ohm speaker with a Quilter amplifier?
(Click for info)
Can I run two cabinets with this head?
(Click for info)
Can I plug the headphone out of the amplifier into a Mixer or Monitors?
(Click for info)
Can I use this amp to power speakers inside my dead fender / marshall / orange / blackstar amp?
(Click for info)
Why does the direct out seem weak when going into Line In?
(Click for info)
I hear a click or a pop when turning the product on is this normal?
(Click for info)
Does plugging into the headphone jack defeat speaker out?
(Click for info)
Can a controller control two amps at once?
(Click for info)
Do Quilter Speakers come with a speaker cable?
(Click for info)
Is a case included with this?
(Click for info)
Can I make my own footswitch for MicroPro amps?
(Click for info)
Can I use this without a Cab?
(Click for info)
I see a spark when plugging in a 45 Series product.
(Click for info)
Can I use the 45 Series product without a speaker?
(Click for info)
Is it safe to run the Bass Block at 2 Ohms?
(Click for info)
Can I power the 45 Series blocks from my pedal power supply board?
(Click for info)
Does the output go to SPEAKER & HEADHONEat the same time?
(Click for info)
Why was the Aviator Series discontinued?
(Click for info)
Where is the cabinet simulation in the signal chain?
(Click for info)
Why is the footswitch not working on my selectable footswitch?
(Click for info)
My BlockDock Retention Plate is Missing.
(Click for info)
Can I use Both inputs at the same time on the Bass Block 800?
(Click for info)
Why can’t I find your amps in my local store?
(Click for info)
Is the 9 volt jack an output or an input?
(Click for info)
Can I use my HD cab as a bass amp?
(Click for info)
Why was theMicroBlock 45 discontinued?
(Click for info)
How did you come up with the voices? (1,2,3)
(Click for info)
Why was the 101 Mini Head discontinued?
(Click for info)
Is the MicroBlock 45 cab sim out too?
(Click for info)
How deep is the 12 inch BlockDock cabinet? I want to try a different speaker.
(Click for info)
What is the wattage at 4 ohms?
(Click for info)
What footswitch do you recommend for the OD 200?
(Click for info)
Can I mount a different speaker in the BlockDock 12?
(Click for info)
Why was the Tone Block 201 discontinued?
(Click for info)
Does the Frontliner 2x8W work in stereo?
(Click for info)
If I plug into the Aux input can I get full output power?
(Click for info)
Do you make a padded carrying case for this accessory controller?
(Click for info)
I’d like a schematic for a footswitch for the OD200.
(Click for info)
Why was the Pro Block 200 discontinued?
(Click for info)
Can I use two voices at once with a Y cord or use an AB switch?
(Click for info)
What was “Old Number One”?
(Click for info)
FX loop seems like it is muted or not working…
(Click for info)
What Block Style amplifiers are compatible with this speaker?
(Click for info)
What sizes are the pedal flats available in
(Click for info)
What is the return policy for Custom Shop orders?
(Click for info)